User manual

APS User Manual
195
Parameter Description
Port: Physical port of the switch.
Timer Values: To set the GARP Join Timer, Leave Timer and Leave All Timer, the units are
set in micro seconds.
Join Timer: The default value for the Join Timer is 200ms.
Leave Timer: The default value for the Leave Timer is 600ms. Valid values
are 600 to 1000ms.
Leave All Timer: The default value for the Leave All Timer is 10000ms.
Application: The only supported application currently is GVRP.
Attribute Type: The only supported Attribute Type currently is VLAN.
GARP Applicant: This configuration is used to configure the Applicant state machine
behaviour for GARP on a particular port.
normal-participant: In this mode the Applicant state machine will operate
normally in GARP protocol exchanges.
non-participant: In this mode the Applicant state machine will not
participate in the protocol operation.
Fig. 87 GARP Configuration