User manual

APS User Manual
232
3. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
Receiver ID: The "Receiver ID" input field allows the user to input the receiver ID.
Currently one ID is supported as one collector is supported.
IP Type: Here you can select to whether the Collector has an IPv4 or IPv6 Address.
IP Address: Enter the IP Address of the s-Flow Agent Collector. The switch will send all s-
Flow information to the collector.
Port: Enter the port that the collector uses to listen to s-Flow requests. Port Range
is 1 – 655365.
Default is 6343.
Time Out: This is the duration during which the collector receives samples, once the
duration has expired the sampler stops sending the samples. Valid values
are within the range of 0-2147483647.
Default is 0.
Datagram Size: The maximum UDP datagram size to send out sFlow samples to the receiver.
The value accepted is within the range of 200-1500 bytes.
Default is 1400 bytes.
Fig. 112 s-Flow Agent Collector Settings