User`s manual

2.13 Firmware Update

This switch provides the capability to update the firmware for new features, customized requests and

system fault recovery. Click the Firmware Update menu to activate this page shown as below:

Before you update the firmware, it is required to correctly prepare the BOOTP server (e.g.

haneWIN DHCP server) and have the firmware file which will be uploaded to the switch by the

BOOTP server available. (Please refer to the instruction guide for setting up the BOOTP server. The

firmware filename, file location, and the IP address to assign to the switch are three important

parameters to setup the BOOTP server.)

When the BOOTP server and the firmware file is ready, click on the Update button to start the

firmware update through the configuration port. Click the Back button to cancel this action.

To process the firmware update file will take approximately 40 seconds, assuming no

communication problems between the switch and the BOOTP server, and assuming the firmware file

can be located by BOOTP server.