User's Manual

8
WARNING
Warning
注意
2 INSTALLATION
2.1 General
2.1.1 Safety Instructions
Before proceeding with installation, please take note of the following safety instructions and read
through this installation manual carefully.
SAFETY INSTRUCTION
SAFETY INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
Do not open the case of
the equipment. Only qualified
personnel should work inside the
equipment.
WARNING
TURN OFF THE POWER BEFORE
PROCEEDING WITH INSTALLATION.
Proceeding with installation with the
power on could cause electrical shock or
fire.
AVOID INSTALLING THE EQUIPMENT
WHERE THERE IS DIRECT CONTACT
WITH RAIN FALLING OR WATHER
SPLASH.
Electrical shock or fire could be resulted
if water leaks into the equipment.
PLEASE FOLLOW THIS
INSTRUCTION MANUL TO PROCEED
WITH THE INSTALLATION.
AMEC and your local agent/dealer will
not bare any responsibility of equipment
damage or personnel injury due to
improper installation.
Warning Label
A warning label (Figure 2-1-1) is
attached underneath the equipment.
Warranty of the equipment will be invalid
if this label is detached or broken. AMEC
and your local agent/dealer will not bare
any responsibility of any damage to the
equipment, or damage in related to the
equipment, personnel injury, and etc.
Reject the equipment if this label is
detached or broken. Please contact your
local agent/dealer if this label is missing.
MAKE SURE THE POWER SOURCE
AND THE POWER INPUT OF THE
EQUIPMENT ARE COMPATIBLE.
Damage to the equipment and fire could
be resulted if the power sources are not
correct. Please check the correct power
input on the adaptor.
Figure 2-1-1 Warning label
Name: Warning Label
No Warranty if this label is
detached or broken.
保固撕毁无效