User's Manual

4 MANDO-301/303 CONFIGURATION

4.1 Configuration Start-up

Step 1: Connect the AtoN device with PC/Laptop via RS-232 serial port. Prepare a RS-232/USB

converter when RS-232 serial port is not supported by your PC/Laptop.

Step 2: Connect the AtoN device with 12V DC (10A) power source. It is highly recommended to

use a power adapter stabilizing the power source.

Step 3: Power on the AtoN device.

Step 4:Turn on PC and load AMEC Configuration Program CD. And make sure it has been properly

installed on your PC/Laptop.

Step 5: Double click and start AMEC Configuration Program.

*NOTE: All message assignments and intervals must be defined and approved by the

appropriate competent authority, such as the local port authority where the AtoN

device is installed.