Installation Instructions
DON’TsDOs
1
BEFORE
YOU BEGIN
•
Use these ps as a guide, not as a replacement for the Allura
Fiber Cement Installaon Manual which can be downloaded at
www.allurausa.com under the Resources Tab in the Technical
secon. Review the manual in its enrety and all applicable building
codes prior to installaon.
• Wear appropriate safety equipment—dust mask or respirator, eye
protecon, hard hat, and cut-resistant gloves as appropriate.
• Allura currently produces 2 dierent Shake panel systems. To nd out which
installaon guide applies to your product, please call 1-844-625-5872.
• Do not install quesonable
product. Contact Allura
Consumer Service at
1-844-625-5872
• Mulshake must be installed to structural framing.
• Mulshake and individual shakes must be installed
over wall construcon with framing spaced no more
than 24" O.C. and a minimum of 7/16" OSB or
1/2" plywood sheathing.
• Siding must be applied over a water-resistant barrier
in accordance with local building code.
• Do not fasten ber cement
siding over non-structural
sheathing thicker than 1"
without re-establishing a
structural fastening surface.
SHEATHING
& WRAPS
3
STORAGE &
HANDLING
•
Keep siding covered, o the ground on a clean, at, and
level surface that is protected from direct
exposure to weather.
• Carry shake panel on
its narrow edge.
• Never install siding that is wet.
2
MULTISHAKE | Basic Installaon Guide
For complete installaon instrucons, go to www.allurausa.com
5
FASTENERS
•
We recommend using corrosion resistant, double
hot-dipped galvanized or stainless steel nails.
• Do not use D-head nails,
staples, nishing nails and/or
construcon adhesives to
install ber cement siding.
Ring Shank
Siding Nail
Roong
Nail
Siding
Nail
Ribbed Wafer
Head Screw
CUTTING
•
Do not score and snap
ber cement.
• Do not cut ber cement
without proper venlaon.
4
• Use appropriate personal protecve equipment (PPE). Refer to the
Fiber Cement Installaon Manual for details.
• Cut ber cement outdoors when possible.
• Use a polycrystalline diamond-pped ber cement blade for circular,
miter, and table saws.
• When using a circular saw or mechanical shears, cut ber cement
siding face down.
• When cung Allura Fiber Cement Mulshake with Allura ColorMax
®
nish, leave the protecve lm on the siding unl it is nailed to the
substrate, then remove before applying the next course.
Face down