Instructions / Assembly

ALLURE ALUMINUM GARDEN FENCE

ASSEMBLY INSTRUCTIONS

Parts Included In Package:

Pickets – 6 Short Pickets & 2 Tall Pickets

Rails – 2

Screws – 20

Screw cover caps – 4

Corner connectors – 2

Tools Required:

Phillips Screw Driver

Scissors

Optional-

Power drill with Phillips head bit

o Caution- Adjust the torque setting on the power drill to release at point when

the screw head is flush with rail. Too much torque might snap the screw head.

Also please wear safety glasses while using power drills.

Fence Section Assembly:

Step 1: Take out all the components from box, and line up the pre-drilled

holes in the pickets with those of the rails as seen in the Figure A above. Please

make sure the tall pickets are at the end.

Step 2: Using the screws in the package, fasten the pickets to the rails as

shown above using a Phillips screw driver or a power drill.

Step 3: If you have more than one section, assemble all sections similarly

(repeating steps 1 & 2) before attempting to connect the sections together.

Figure A

PAGE 1
ALLURE ALUMINUM GARDEN FENCE ASSEMBLY INSTRUCTIONS Parts Included In Package: Pickets – 6 Short Pickets & 2 Tall Pickets Rails – 2 Screws – 20 Screw cover caps – 4 Corner connectors – 2 Tools Required: Phillips Screw Driver Scissors OptionalPower drill with Phillips head bit o Caution- Adjust the torque setting on the power drill to release at point when the screw head is flush with rail. Too much torque might snap the screw head. Also please wear safety glasses while using power drills.
PAGE 2
CAUTION: Although using a power drill may reduce assembly time, a high torque setting may snap or strip the screw head. Use caution while assembling sections using power drills. Figure B Fence Installation: For Corner Sections Assembly: Using the corner connector, align the two fence sections perpendicular to each other, and fasten the connectors onto the rails using a screw driver or a power drill as seen in Figure B. Repeat for all corner section connections.