Instructions / Assembly

Connect hoses* as shown in the diagram below.
12
HOSE CONNECTION
Although drain connection may vary depending on
your circumstances, a typical installation is shown
at left. After the tub has been located over the exist-
ing drain, a “stub” is run up from the existing drain
in the floor. A threaded coupling is placed over the
stub, followed by a compression ring. Then the
threaded coupling is screwed onto the drain, form-
ing a watertight seal.
DRAIN CONNECTION
1. Tub Floor
2. Tub Drain
3. Compression Ring
4. Threaded Coupling
5. Existing “Stub” From Floor
1. Cold Water
Faucet
2. Spigot/Diverter
3. Hot Water
Faucet
4. Hand Shower
5. Cold Water
Supply*
6. Faucet-to-Spigot
Line: Cold
7. Hand Shower
Hose
8. Faucet-to-Spigot
Line: Hot
9. Hot Water
Supply*
1
3
4
6
2
5
7
8
9
1
2
3
4
5
To
Overflow
*Water supply hoses not included.