Instructions / Assembly

Note: Since no two customers’ installations will be identical,
these instructions are intended solely as a general reference.
Your installation may vary depending on your circumstances. In-
stallations should be done by a licensed contractor or plumber,
and electrician.
1. Place level on edge of tub.
2. Loosen locknuts on feet.
3. Rotate foot up or down
as needed to bring tub into
level position.
4. When tub is level, tighten
locknuts.
5. Repeat as necessary, until
all four edges of tub show
level.
7
LOCATION AND LEVELING
First, “test fit” the tub by placing it in the position where it will be installed. Be sure the tub’s
drain lines up with the floor drain, and note the position and length of the water inlet hoses*,
ensuring that they will reach the connecting points of your home’s water supply.
Once the tub is in place, it must be leveled. Do this by placing a carpenter’s level on the sides
and edge of the tub, and adjusting the feet. Adjust the feet by loosening the locknuts and
rotating the foot clockwise or counter-clockwise as needed, then tightening the locknuts. Al-
though we check each tub at the factory, movement during shipping may cause adjustments
to be needed. Failure to properly level the tub may cause incomplete drainage, poor door seal
alignment, and other problems.
*Water supply hoses not included.