SDS

ALLURE Metallic Adhesive Paint
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Avoid contact with eyes, skin and clothing. Do not ingest. Wash thoroughly after
handling.
Keep containers sealed until ready for use.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8).
:
Precautions for safe handling
Propylene Glycol
AIHA WEEL (United States, 10/2011). Notes: 2004 Revised Document
TWA: 10 mg/m³ 8 hours.
Titanium Dioxide
OSHA PEL (United States, 6/2010).
TWA: 15 mg/m³ 8 hours. Form: Total dust
OSHA PEL 1989 (United States, 3/1989).
TWA: 10 mg/m³ 8 hours. Form: Total dust
ACGIH TLV (United States, 3/2012). Notes: Substance identified by other sources as a
suspected or confirmed human carcinogen. 1996 Adoption Substances for which the
TLV is higher than the OSHA Permissible Exposure Limit (PEL) and/or the NIOSH
Recommended Exposure Limit (REL). See CFR 58(124) :36338-33351, June 30, 1993, for
revised OSHA PEL. Refers to Appendix A -- Carcinogens.
TWA: 10 mg/m³ 8 hours.
Section 8. Exposure controls/personal protection
Ingredient name
Exposure limits
Hand protection
A respirator is not needed under normal and intended conditions of product use.
Protective gloves should be worn under normal conditions of use.
If contact is possible, the following protection should be worn, unless the assessment
indicates a higher degree of protection: safety glasses with side-shields.
Eye/face protection
Respiratory protection
:
:
:
Body protection
Wear suitable protective clothing.
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Hygiene measures
:
Control parameters
Individual protection measures
Occupational exposure limits
Skin protection
Other skin protection
:
None identified.
This product may contain materials classified as nuisance particulates, which may be
present at hazardous levels only during sanding or abrading of the dried film. Wear a
dust/mist respirator approved for dust when dusts are generated from sanding or
abrading the dried film.
Date of issue/Date of revision
:
3/15/2016
4/9