Operation Manual

34
b>Vib. Only: Vibration only and no ring in case of an incoming call.
c>Vib. and ring: Both ring and vibration in case of an incoming call.
d>Vib. then ring: Ring after vibration in case of an incoming call.
Ring types:
a>Single: Ring only once in the case of an incoming call.
b>Repeat: The ring tone will continuously play in the case of an incoming
call.
c>Ascending: The ring tone will continuously play with a rising volume in
the case of an incoming call.
Extra tone:
a>Warning: A prompt tone for an operating need.
b>Error: A prompt tone given in the case of an operating error.
c>Camp on: A prompt tone produced in the case of a successful network
search.
d>Connect: A prompt tone generated after a calling connection.
Answer mode:
a>Any key: It is used to answering an incoming call by pressing any
key, except the right soft key and the hang -up key.
Meeting/Outdoor/Indoor:
See the "General" section for details.
Outdoor:
See the "general" section in details.
Indoor
See the "general" section for details.
Headset:
Insert the earphone automatically to enter the headset mode. The start
option is not available in this condition, but key a nd automatic answering
modes are offered for selection. See the "general" section in details.
Note: Hold the # key(in dial clock) to activate or deactivate the mute
mode. Incoming calls, short messages and the alarm adopt the vibration,
and other settings are muted in this condition.
Bluetooth: