Operation Manual

3 Start to Use

3.1 Insert SIM Card

PIN (personal identification number), PIN2, PUK (personal unlock key),

IMSI (international mobile subscriber identification) number, network

information, phone book and SMS (short message service) and other data

are stored in your SIM card.

Steps:

1> Hold the power key to turn off your mobile phone, and remove the

battery cover and then the battery.

2> Note: don’t pull out the extractor when inserting the SIM card.

Firstly, inserting the side with the unfilled corner.

Secondly, pushing the SIM card carefully with the card surface upwards

and move it into the groove of the SIM card holder.

3> Put the battery into the battery holder again, and close the battery

cover.

3.2 Insert T-Flash (Storage) Card

1> Hold the power key to turn off your mobile phone, and removing the

battery cover and then the battery.

2> Pushing the T-Flash card carefully with the card surface upwards and

move it into the groove of the T-Flash card holder.

3> Put the battery into the battery holder again, and close the battery

cover.

3.3 Battery & Charge

Indication of battery power:

Your mobile phone can monitor and display relevant information on the

battery.

1> Normally, you can check the remaining power of the battery from the

battery power icon on the top right corner of the screen.

2> The screen will display “Battery Low” when the battery power is

inadequate. If you have selected the prompt tone of any mode out of the

scene modes, the mobile phone will also give out a warning prompt tone.