Operation Manual

9
3> When the battery is charged, the power indicator of the battery icon
will be constantly changing until the battery is full.
Note: The actual standby time and calling duration are related to the use
of the mobile phone, the local network environment, the SIM card and
actual settings.
Warm reminders about battery:
Please don’t store your mobile phone battery at an extremely high or low
temperature, for it will affect the service life of the battery, and shorten
the standby time. The service life of the mobile phone battery is subject
to a certain limit. It is recommended that you would better change a
battery from the original supplier if the performance of the battery has
declined after using it for a period of time.
Use two-in-one charger (charger + signal cable) :
The two-in-one charger can charge the battery via the mobile phone.
1> Connect the signal cable and the charger.
2> Connect the plug at the signal cable end of the two-in-one charger
with the input/output groove of the m obile phone.
3> Insert the plug at the charger end of the two-in-one charger into an
appropriate main power supply socket.
4> When the battery is charged, the power indicator of the battery icon
will be changing until the battery is full.
5> When the battery is full, the power icon will stop changing, and then
you can pull out the plug of the two-in-one charger.
Points of attention on use of battery:
1> Be sure to switch off the mobile phone before you remove the battery.
2> Please use it carefully. A short circuit will occur if the positive pole (+)
and the negative pole (-) of the battery is connected with a metal object
(for example, a coin or clip), it may do damage to both the battery and
the metal object. Make sure that no metal object will be connecte d
simultaneously with the positive pole and the negative pole of the battery
after it is removed and put in a bag.
3> Don’t throw the battery into the fire, or use it under an extremely high