User guide

System Administrator’s Guide – Release 7.5
______________________________________________________________________________________________
Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
Revised: April 9, 2013
Page 56
the prompts. The phone will reboot and connect using the DHCP and
manually entered settings. 0.
10.1.2 Static IP Addressing
If assigning the phones static addresses rather than using DHCP, the following
network settings will have to be entered manually on the phone:
• Boot server (the Allworx server’s IP address or domain name)
• Time Server (optional, can be an IP address or domain name)
• DNS Server IP
• Phone IP
• Netmask IP
• Gateway IP
To update the Static IP Address:
1. Press the CONFIG soft key on the phone.
2. Using the arrow buttons, highlight Network Settings and press the Select
button . If you are prompted for a password, enter “allworx” using the
numeric keypad then press the Select button . The Network Settings
menu displays and DHCP highlights.
3. Press the Select button until the DHCP setting is Disabled.
4. Use the arrow keys to highlight Edit Boot Server. Press the Select button
. Using the phone’s keypad, enter the IP address or the domain name of the
Allworx server. Use the asterisk key ‘*’ for periods. When you are done, press
the Select button .
5. Highlight, select, and enter the remaining settings from the list, above.
6. Press the EXIT soft key repeatedly until you are asked to save the settings.
Press the YES soft key.
7. Reboot the phone by pressing the CONFIG soft key, using the arrow keys to
highlight Reboot Phone, and pressing the Select button . Answer Yes to
the confirmation. The phone will reboot and connect using the DHCP and
manually entered settings. 0.
Note: You may abort an Allworx phone’s boot cycle by pressing the MUTE/DND button
three times. If the phone is running firmware from server software release 7.3 or
lower (phone firmware version 2.3 or lower), press the RELEASE button three
times, instead.
10.1.3 VLAN Settings
If the site’s network utilizes VLANs, additional configuration is necessary.