User guide

System Administrator’s Guide – Release 7.5
______________________________________________________________________________________________
Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
Revised: April 9, 2013
Page 69
11 Configuring Allworx Phones
To configure Allworx IP phones:
1. Navigate to Phone System > Handsets.
2. Check the Show boxes for Allworx Handsets and Allworx Reach
Handsets. The table lists all installed Allworx desk phones and Reach
handsets. 0.
The following settings and actions are available:
Phone
Function
Description
Applies to
Allworx
Desk
Phone
Allworx
Reach
Appl.
Allworx
Generic
SIP
Phone
PBX Station
(Default)
Name of the Handset Preference Group
assigned to the phone. PBX Station
(Default) is the system. Clicking the link will
display the settings of the group. See
Handset Preference Groups on page 71
for more information.
Yes Yes No
View
Configuration
Enable viewing and modifying the phone’s
PFK configuration and Handset Preference
Group membership. See Handset
Preference Groups or Programmable
Function Keys (PFKs) on page 83 for more
information
Yes Yes No
Add Call
Appearance
Enable creating another Call Appearance
for this phone. Multiple Call Appearances
enable a single phone to handle calls for
users.
Yes No No
Reboot Restart the phone. The reboot occurs after
a short delay on an idle phone. If the
phone is in use, the reboot will not start
until the phone is idle. A Reboot Allworx
Handsets button is available at the top of
the SIP Handsets section of the page to
reboot all Allworx phones with one action.
One handset reboots every 10 seconds,
until all phones reboot.
Yes Yes No