Owner manual

11. On success Pamela display will blank for a couple of seconds and then
display '120'.Pamela is nowready for use with new firmware.
On failure Pamela will display 'Err' there for check volume, check playbackwas not
interrupted, repeat above process to try again.It may take a few tries to get levels
right. Do not panic if it fails, just try again.
A partly updated Pamela will just show the pulse symbol on start up - this
indicates Pamela is in a part updated (limbo) state and is waiting for the audio file to
be played in correctly (i.e jumping direct to step 6 above) before functioning normal
again.
Updating the firmware will will wipe any saved setting.
To see the current firmware version installed, power Pamela on with the start/stop
button held down. The firmware version will be display on the LED. This manual is for
the firmware version 0108 (As shown on title page).
Please use only official firmware audio files when made available from the
BusyCircuits website.
ALM-001 - ‘Pamela’s Workout’
2