Owner manual

Special special symbols are used on the display to represent modifier values. They
are;
Indicates a divisor.
Two of these indicate an ‘always on’ gate when clock is
running.
‘Pulse(s)’ indicate special trigger that provides a single pulse
on clock start, another when the clock stops or one for each
(two pulses)
A triplet value.
A power of two. Used to represent large divisors. For
example; 9P = /512, 8P = /256
To change the selected modifier value, twist the program knob. This will cycle
through and set from available trigger modifier values.
Extended Per Trigger Adjustment
Each trigger output can be further adjusted through extended settings. These allow
for the trigger or pulse width to be varied, timing delays added, random skipping and
the settings of an offset or rotation to a divisor modifier.
With a trigger screen selected, pushing and holding the program knob for
approximately 1 second will access extended triggerparameter selection. The various
parameters can be cycled through and edited again by use of the program knob. Each
screen is represented by the selected trigger number, a symbol and the corresponding
value.
ALM-001 - ‘Pamela’s Workout’
7