User`s manual

11
S2000 SERIES & S2300 SERIES COMBO & C2200
Suppose that you have selected Fixed Antenna in the Antenna
Connection window.
1. Tuner: Show you the LNB selected.
2. Satellite: All selected satellites in the satellite list are displayed in
this item.
Press keys to select the satellite in circle. Or press OK
key to pop up the drop-down list, then select the desired satellite in
thelistandpressOKkeytoconrm.
3. LNB Freq, Transponder, DiSEqC1.0, DiSEqC1.1: The same
operation as the above.
4. 22K, Polarity: You can press keys to select in circle.
Part B: Motor
Suppose that you have selected Motor Antenna in the Antenna
Connection window.
1. Tuner: Show the LNB
2. LNB Type: Select the proper LNB type.
3. Motor Type: Select between DiSEqC1.2 and USALS. If you
select DiSEqC1.2, the following Local Longitude and Local
Latitude items will turn grey.
4. Delete All: Press OK key to pop up the dialogue “Are you sure to
clear set satellite position of this tuner?”. Press OK key at the
Yes button to clear all the memories about the position of the
satellites that are connected to the current tuner.
5. Motor Setting: Press OK key to the Motor Setting window.
Satellite: Press keys to select the satellite in circle. Or
press OK key to pop up the drop-down list, then select the desired
satelliteinthelistandpressOKkeytoconrm.
Transponder: The same operation as the above.
Position No., & Save: The range is from 0 to 63. “0” delegates the
original position.
You can select the proper value when you has rotated the antenna.
Go to X: Press OK key to pop up the drop-down list, select the
proper position (reference or from 1to 63) to realize the selected
position.
West <Save> East: Press key to turn west, while press key
to turn east. Press OK key to pop up the dialogue “Are you sure
to change this satellite’s position?”. Press OK key at the Yes button to
save the current position, or press OK key at the No button to cancel
the operation.
Recalculation: Press OK key to pop up the dialogue “Are you sure to
change this satellite’s position?”. Press OK key at the Yes button to
recalculation.
6. Limit Setup: Press OK key to pop up the Limit Setup window.
Limit Setup: Press keys to switch among Disable
Limit, East Limit and West Limit.
Limit Setup: Move cursor to the Limit Setup button. You can
press key to turn west , or press key to turn east.
Go to Reference: Press OK key to go to reference. If you select
Disable Limit in the above Limit Setup item, this button will turn
grey.
7. If select USALS, Delete All item will turn grey.
Local Longitude, Local Latitude: Press keys to
switch between West and East, or press these keys again to
switch between North and South..
Press OK key to enter into the editing mode. Use numeric keys
(0-9) to input the longitude or latitude, press MENU key or EXIT
key to exit. The range of the longitude is from 0 to 180,while the
range of the latitude is from 0 to 90. If the inputted value is not
in this range, system will pop up a dialogue “Out of Range”
when you exit from this window. You can press OK key to close
this dialogue.
8. Motor Setting: Press OK key to enter into the Motor setting window.
Satellite, Transponder: Press keys to select satellite
or transponder, or press OK key to pop up the drop-down list
and select in the list.