User`s manual

18
S2000 SERIES & S2300 SERIES COMBO & C2200
7.11 Audio
1. Press AUDIO key to enter into the Audio window.
2. Press keys to select among Left, Right, Stereo, and Mono.
3. Changing the audio mode is only connected with the current channel, not all the channels.
4. Press MENU or EXIT key to close this window.
7.12 Recall
Press←PRkeytoswitchthecurrentchanneltothepreviouschannel.
7.13 FAV
1. Press FAV key to pop up the favourite group window.
2. Press keys to select the favorite group. Press PR+, PR- keys to select the channel up or down. Press OK key at the selected
channel to view it in full-screen. Press MENU or EXIT key to exit.
3. If there is no favorite channel, system will inform “ No FAV Channel!” when you press FAV key.
7.14 Teletext
Press TXT key to open the teletext on the screen. If there is no teletext, system will inform “No Teletext Data”. Press EXIT key to exit.
TROUBLE SHOOTING
Problem Possible causes What to do
The display on the front panel does not light
up.
Main cable is not connected.
Check that the main cable is plugged into the
power socket.
No sound or picture, but the front panel
shows red light.
The receiver is in standby mode. Press the standby button.
No sound or picture.
The satellite dish is not pointing at the
satellite.
No signal or weak signal.
Adjustthedish.Checkthesignallevelinthe
Antenna Setup menu.
Check the cable connections, LNB and other
equipment connected between the LNB and
thereceiver,oradjustthedish.
Bad picture / blocking error.
The satellite dish is not pointing at the
satellite.
Signal is too strong.
Satellite dish is too small.
LNB noise factor too high.
The LNB is faulty.
Adjustthedish.
Connect a signal attenuator to the LNB
input.
Change to a larger dish.
Change to an LNB with lower noise factor.
Change the LNB.
The picture is not showed on the screen,
when switching on.
The system is connected by RF
leads.
ChecktheUHFchannelxedinyoursystem
and tune the UHF channel properly.
There is interference on your digital satellite
channels, an existing terrestrial channel or
video signal.
The system is connected by RF leads and
the output channel of the receiver interferes
with an existing terrestrial channels or Video
signal.
Change the receiver output channel to
a more suitable channel, or connect the
system by SCART leads.
The RCU is not working.
Battery exhausted.
RCU is incorrectly aimed.
Change the batteries.
Aim RCU at the receiver, or check that
nothing blocks the front panel.
Note: If you have tried all of the actions suggested above, without solving the problem, please contact your dealer or service provider.
Please note that new software may change some of the functionality of the receiver.
The manufacturer holds the rights of any changes.
Specicationsaresubjecttochangewithoutnotice.
For any typographical errors, the manufacturer assumes no responsibility.