Madison Sauna Installation & Owner’s Manual
Read this entire manual through to the end before proceeding with the assembly. Madison Installation & Owner’s Manual Thank you for your purchase of your Madison sauna! Should you have any questions during assembly, please feel free to call us at 888.355.3050, or email sales@almostheaven.com. Regular business hours are 9-5 EST, M-F. Your Madison Indoor Sauna is specifically designed to utilize your existing floor.
Step 1. Connect the Four Floor Risers Fasten the four floor risers together using the predrilled holes as a guide, being sure the two shorter boards are located on the sides and the two longer boards are on the front and back. Use a framing square to ensure the assembly is square. (1-3) Image 1 Image 2 Image 3 Step 2. Position Wall Support Rails Align each wall support so that the angled cuts make a corner, placing the shorter supports on the sides and the longer supports on the front and back.
Step 4. Position Wall Sections C & D Position wall section C into the groove of the back rail. Attach it to wall section B by way of the tongue and groove fit. Position wall section D on the side rail, pushing it flush against the back rail. Align the two panels so they are flush and fasten them together using the 2” screws. (14-16) Image 14 Image 15 Image 16 Step 5.
Step 7. Assemble and Position Roof Support Rails Align each roof support rail so the angled cuts join together to make a 90-degree angle, placing the shorter supports on the sides and the longer supports on the front and back. Fasten them together using 2” screws through the predrilled holes. Place the assembly on top of the wall sections so that the wall sections fit snugly into the groove. When in place, secure the assembly to the walls using three 2” screws on each rail.
Next, position the footrest by resting it on the supports on each side of the sauna. Secure each side of the footrest to the support using 2.5” screws through the pre-drilled holes on the top and front of the foot rest. (31-33) Image 31 Image 32 Image 33 For the final step of the bench and footrest assembly, locate the lower side bench and cleat with pre-drilled holes. Position the side bench against the footrest so that the top of the bench is flush with the footrest.
The LED light can be controlled from within the sauna using the controls tacked onto the side of the backrest. Using the three buttons, the LED light can be turned on and off, made dimmer or brighter. (41) Image 41 Step 10. Accessories Install the vent hole cover with the provided screw and washer. (42) Image 42 Install the door handle on the door. (43-44) Image 43 Image 44 Step 11.