Instructions / Assembly

Your Almost Heaven Sauna includes a genuine Finnish heater that is manufactured by Harvia Oy, the world

leader in exceponal sauna heaters. This brief guide is intended to supplement the manufacturer’s manual

and will give you simple instrucons on how to install the Harvia heater in your Almost Heaven Sauna. A li-

censed electrician should perform all electrical work, and Almost Heaven Saunas is available to assist with

any quesons you or your electrician may have. You may contact us at 888.355.3050 or 304.497.3991 for

technical assistance.

4.5kw and 6.0kw Heaters

 30-amp double pole breaker

 10/2 wire if under 30’ from power source; 8/2 wire if over

 Hard wire directly to heater

 Do not use GFCI with this heater

 Use copper wire with 90°C insulaon

8.0kw Heaters

 40-amp double pole breaker

 8/2 wire

 Hard wire directly to heater

 Do not use GFCI with this heater

 Use copper wire with 90°C insulaon

2. Drill hole to bring power to sauna heater. A

typical locaon would be on the wall below and

behind where the heater will be mounted, but

the wire can come in at any point most conven-

ient and accessible to the power source. Bring

conduit into sauna in compliance with local

electrical codes. (Heater will be centered over

the vent holes near the oor of the sauna.)

1. Aer unpacking your Harvia heater, detach

the stone guard from the top by removing the

two screws that aach it to the backside of the

heater. Aer the screws are removed, hold the

stone guard at the front of the heater and pull

up rmly and quickly. The guard will release

from the heater and will be reaached in the

same way aer the stones are inserted.

Screw Locaon