User manual

Part 2 - USE AND MAINTENANCE INSTRUCTIONS

3.1 - Metal grease filters

1 - Cleaning

These filters must be washed when LED 0/1 Motor starts to flash, or at

the most once every 2 months, using a normal household detergent;

their compact size also enables them to be washed in a dishwasher.

2 - Removing the filters

Remove one filter at a time, supporting

it from below and pulling back the

stainless steel handle (fig.29 ). Replace,

making sure that the handle is still facing

towards the outside.

3 - Enabling the alarm signal

The hood is already set up to trigger an

alarm indicating saturation of the metal

grease filters, so this function does not

need to be enabled.

4 - Resetting the alarm signal

To turn the alarm signal off, proceed as follows:

- Turn off the lights and the suction motor;

- Press the Speed + button for at least 3 seconds, until the LEDs flash in confirmation.

In any case the saturated filters alarm will only come into operation when the suction

motor is turned on.

WARNING: always comply with the maintenance and replacement times

indicated, in order to avoid a possible risk of fire when the filters are saturated

with grease.

3.2 - Activated charcoal filter

1 - Operation

The activated charcoal filter is only fitted in recirculation type hoods. It

will retain odours until it becomes saturated. It cannot be washed or

regenerated, and must be replaced when the Intensive Speed LED starts

to flash, or at least once every 4 months of use. Attention: in recirculation

type hoods the 0/1 Motor LED may

start to flash as well as the Speed +

LED. This indicates that as well as

replacing the activated charcoal

filter, it is also necessary to perform

maintenance operations on the

metal grease filters (see paragraph

3.1).