Installation Sheet
FM307001
Flush Mount/ Wall Mount
NOTICE
• The important safeguards and instructions outlined in this sheet cannot cover
all possible conditions and situations that may occur. It must be understood
that caution and certain care factors must be followed. These instructions are
provided for your safety and we highly recommend that a licensed, trained
electrician install this unit.
• This fixture is designed to be mounted on a correctly installed standard round
or octagon box OR through a wiring box with a plaster frame. The box must be
securely mounted to the structure of the building. The crossbar and hardware
supplied should be used, directly mounting the fixture to the outlet box may
make it impossible to correctly align the fixture.
Important: ALWAYS be sure to
disconnect power before re-lamping or wiring the fixture. Read these instructions completely before starting installation.
To avoid the risk of fire and/or shock fixture must be installed in compliance to national and local electrical and building codes.
If an existing fixture is being replaced take special notice of which wires were connected in the outlet box.
DO NOT SEPARATE ANY WIRES THAT MAY BE EXISITING IN THE JUNCTION BOX
DO NOT DAMAGE THE INSULATION OF JUNCTION BOX WIRES.
In Regular circumstances the BLACK wire will be “live”, WHITE will be “neutral” and GREEN or BARE COPPER will be “ground”. In older buildings it is always good practice to
reconfirm the polarity of the wiring.
ASSEMBLY INSTRUCTIONS
CANADA : 102 ∙19028 27
TH
Ave. - Surrey, BC V3Z 5T1
USA : 3035 E. Lone Mountain Rd - Las Vegas, NV, 89081
www.aloralighting.com
P.
1.833.MY ALORA (692.5672)
WARNINGS AND CAUTIONS
TECHNICAL SUPPORT
1.833.MY ALORA(692.5672)
technicalsupport@aloralighting.com
1a.
1b.
1c.
1d.
1e.
1f.
2b.
2a.
3a.
3b.
Step 1
Step 2
Step 3
You are now ready to enjoy your fixture.
Install recommended lamp (3b) (not provided) (referred on the socket label
for maximum wattage and type) to fixture socket (2b) and restore power. *If
fixture has LED (Light Emitting Diodes) lamp installation is not required*
Connect fixture wires to junction box wires using the marrettes provided (1b)
(white to white “N”, black to black “L”, green to green “G”). Attach fixture
assembly (1e) to mounting crossbar (1c) using cap nuts (1f). To secure
canopy (2a), slide over socket (2b) and thread socket cover (3a) turning
clockwise.
Remove the mounting crossbar (1c) and the fixture assembly (1e) from within
the canopy (2a). Attach the mounting crossbar (1c) to the junction box (1a)
using two junction box screws (not provided) (1d).