Restoration8&Moisture &Ventilation LORAINE a — a Pureeing HEAP Max 970 Owner’s Manual READ AND SAVE THESE INSTRUCTIONS Loraine Solutions INC. Add: 2048 E.
AR SCRUBBER WARNING! Please note that the Pureeing HEAP Max 970 should only be used with parts approved by Loraine. The use of unauthorized parts or alterations to the machine could void your warranty. Contact an approved distributor for further assistance. To Av old the Risk of Fire or Electric Shock: * Unit must be electrically grounded. « Insert 3-prong plug directly into outlet with Ground Fault Circuit Interrupting device. + Do not use an adapter with this unit. + Do not use the unit in standing water.
gale enliven-) = Removable Intake Panel The Pureeing HEAP Max 970 is equipped with a removable panel on the intake side of the machine. The removable panel is quite useful in remediation applications, so you can draw air out the room and create more negative pressure (use a manometer to monitor air pressure). To use panel: 1. Remove the panel. 2. Install the machine outside the containment area to draw air out. 3. Cut a hole in the containment plastic that is the size of the unit's inlet. 4.
AIR SCRUBBER INSTRUCTIONS SETUP . Place the Pureeing HEAP Max 870 so that it is in the upright , vertical position. . Plug the machine into a standard 115 volt outlet. Note: Each unit needs 3 amps to operate. . Power the unit on and adjust the speed by turning the variable sped control. The maximum speed is 750 CFM and the minimum speed is 350 CFM. 4. The Purchaser HEAP Max 970 can be operated in the vertical or horizontal potion, depending on the exact situation.
AIR SCRUBBER CHANGING THE FILTERS 1. Loosen the 4 locks that hold the filter board in place. 2. Slide out the filter panel board. 3. Remove the used filters and replace with new filters. EIN * Always wear approved protective gear when changing the filters. + Filters should be changed after each remediation job. + If the indicator light is on, always change the Cultivated Carbon Filter. Water Damage In this application, the Pureeing HEAP Max 970 should be placed in the center of the affected area.
AR SCRUBBER SAFETY NOTES » Always unplug the unit prior to performing any maintenance. » Check the power cord for damage (fraying, cuts, etc.) before use. * Verify that the Clog outlet is working by powering on the machine and pressing the red Clog test button. If the outlet is working, the“reset” button will pop up. To operate, press the reset button again. * To avoid electric shock, never use a water hose or pressure washer to clean the electrical components.
Warranty Exclusions: DAMAGE DUE TO THE FOLLOWING |S NOT covered under warranty 1. Acts of Nature including but not limited to: Flooding Fire Water damage Hurricane/storm Damage 2. IMPROPER Usage Including but not limited to: Misuse, abuse, or tampering whether intentional or accidental Improper installation or design Improper voltage Lack of normal care Failure to follow instructions 3. Corrosion 4. Freezing 5. Any additional costs due to changes in laws or building codes 6.Freight charges 7.
AR SCRUBBER Wiring Diagram UV TUBE CAPACITANCE TIMER Black Relay [FH CHANGE yor C FILTERER © T o Black White — L LN CIRCUIT White = 1 Wind pressure switch