Restoration&Moisture&Ventilation LORAINE me Clean shield HEAP 550 Owner's Manual READ AND SAVE THESE INSTRUCTIONS Loraine Solutions INC. Add: 2048 E.
a Stein EZEKIEL Please note that the Clean Shield 550 should only be used with parks approved by Floral. The use of unauthorized parts or alterations fo the machine could void your warranty. Contact an approved distributor for further assistance. To Avoid the Riga of Fire or Electric Shock: = Unit must be electrically grounded. =» Insert 3-prong plug directly inch outlet with Ground Fault Circuit Interrupting device. » Do not use an adapter with this unit. + Do not use the unit in sending water.
i En a Removable Intake Panel The Clean Shield 550 Is equipped with a removable panel on the Intake side of the machine. The removable panel is quite useful in remediation applications, so you can draw air out the room and create more negative pressure {use a manometer fo monitor air pressure). To use panel: 1. Remove the panel. 2. Install the machine outside the containment area fo draw air out. 3. Cut a hole in the containment plastic that is the size of the unit's inlet. 4.
tps EL INSTRUCTIONS SETUP 1. Place the Cleansed HEAP 550 so that it is in the upright, vertical position. 2. Plug the machine into a standard 115 volt outlet. Noe: Each unit needs 3 amps to operate. 3. Power the unit on and adjust the sped by turning the variable speed control. The maximum speed is 550 CFM and the minimum speed is 270 CFM. 4. The Clean Shield 550 can be operated in the vertical or horizontal potion, depending on the exact situation. At this point, adjust the machine to the optimal position.
AIR SCRUBBER CHANGING THE FILTERS 1. Loosen the 4 locks that hold the fitter board in place. 2. Slide out the filler panel board. 3. Remove the used filters and replace with now filters. = Always wear approved protective gear when changing the filters. + Filters should be changed after each remediation job = If the indicator light is on, always change the Cultivated Carbon Filter APPLICATIONS Water Damage In this application, the Clean Shield should be placed in the center of the affected area.
LG Sentinel SAFETY NOTES = Always unplug the unit prior to performing any maintenance. + Check the power cord for damage (fraying, cuts, etc.) before use. « Verify that the GFC| outlet is working by powering on the machine and pressing the red FC! test button. If the outlet is working, the “reset” button will pop up. To operate, press the reset button again. = To avoid electric shook, never use a water hose or pressure washer Io clean the electrical components.
naan Warranty Exclusions: DAMAGE DUE TO THE FOLLOWING |B NOT covered under warranty 1. Acts of Nature including but not limited to: Finding Lira ‘Water damage Americanization damage 2. IMPROPER Usage Including but not limited to: Misuse, abuse, or tampering whether intentional or accidental improper Installation of design improper voltage Lack of normal care Allure to follow Instructions. 3. Corrosion 4. Freezing § Any additional costs due to changes in 'aws or building codes ©.Freight charges 7.
AG Seine Wiring Diagram Blue Black FILTERER Wind pressure switch ote White LINE Black POW White Green GND