OWNER S MANUAL REMOTE CONTROLLER Please read this Owner's Manual carefully before operation. Save this manual in a safe place for future reference.
3.5 After setting the TIMER, there will be a one-half second delay before the remote controller transmits the signal to the Air Conditioner. Then , after approximately another 2 seconds, the set temperature will re-appear on the digital display . Change the TIMER To change the TIMER ON/OFF time, just press the corresponding TIMER button and reset the time. NOTE The setting time is relative time. That is the time set is based on the delay of the current time.
Remote Controller Specifications TIMER Operation Model R51D/E R51D/CE Rated Voltage 3.0V(Alkaline dry batteries LR03 2) Lowest Voltage of CPU Emitting Signal 2.0V Reaching Distance Signal Range 8m (when using 3.0 voltage, it Gets 11m) Environment -5 C 60 C ~ Introduction of Function Buttons on the Remote Controller 1 2 SET TEMPERATURE 4 AUTO COOL DRY HEAT O C) FAN HIGH MED LOW 8 3 TEMP.
TEMP Button : Press the button to decrease the indoor temperature setting. TEMP Button : Press the button to increase the indoor temperature setting. ON/OFF Button: Push this button to start the unit operation. Push the button again to stop the unit operation. MODE Select Button: Each time you push the button, a mode is selected in a sequence that goes from AUTO COOL DRY HEAT and FAN, as the following figure indicates: 1 NOTE 1.
12 13 LOCK Button: Push this button to lock in all the current settings. To release settings, push again. (Use a 1mm little round stick to push this button ) POWERFUL Button: Press this button on cooling/heating mode to go into powerful cooling (heating)operation.Press again to cancel it. Note: The unit will automatically revert back to the previous operational mode after continuously operating under the powerful cooling mode.