Datasheet

3.3 Connections
3.3.7. CPL cable
The CPL cable shown in figure 3.10 connects the LDD to the TPG and external power
supply, using a DE-9 connector on the LDD side, yellow/black banana connectors for
Bias-T operation, Lemo 00 for LDD power supply, BNC for LDD timing signal and
red/black banana connectors for TPG power supply
Figure 3.10.: CPL cable.
The LDD side consists of a D-sub-9 connector, composed of 9 pins as shown in
figure 3.11 and described in table 3.6.
Figure 3.11.: DE-9 connector pinout numbering.
1 + external power supply (red banana cable)
2 center of LEMO connector (+12 V)
3 (not connected)
4 center of BNC connector
5 + yellow banana cable
6 - external power supply (black banana cable, associated with red banana cable)
7 LEMO ground (chassis)
8 BNC ground (chassis)
9 - black banana cable (associated with yellow banana cable)
pin nb purpose
Table 3.6.: CPL cable connector pinout.
c
2012 SA 37