Datasheet

7.2 Calibration procedures
7.2.1. TCU interlock level setting procedure
This procedure allows to set the TCU interlock level.
1. switch off the TCU
2. unplug the power cable
3. remove the cover to access the main board following step 2 of the previous
procedure.
4. locate the J9 Interlock connector
5. position the associated jumper according the desired type of interlock:
• NC (normally closed): pins (4) and (5)
• NO (normally open): pins (3) and (4)
3
4
5
Figure 7.9.: TCU board J9 Interlock connector.
c
2012 SA 83