Specifications

exp
MP-74
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
exp
To configure Multiprotocol Label Switching (MPLS) experimental (EXP) levels for a Frame Relay
permanent virtual circuit (PVC) bundle member, use the exp command in Frame Relay
VC-bundle-member configuration mode. To remove the EXP level configuration from the PVC, use the
no form of this command.
exp {le
vel | other}
no exp
Syntax Description
Defaults EXP levels are not configured.
Command Modes Frame Relay VC-bundle-member configuration
Command History
level The MPLS EXP level or levels for this Frame Relay PVC bundle member.
Th
e range is from 0 to 7.
A PVC bundle member can be configured with a single level, multiple
in
dividual levels, a range of levels, multiple ranges of levels, or a
combination of individual levels and level ranges.
Levels can be specified in ascending or descending order (although a
s
ubsequent show running-config command will display them in ascending
order).
Examples are as follows:
• 0
• 0,2,3
• 6-5
• 0-2,4-5
• 0,1,2-4,7
other Specifies that this Frame Relay PVC bundle member will handle all of the
r
emaining MPLS EXP levels that are not explicitly configured on any other
bundle member PVCs.
Release Modification
12.2(13)T This command was introduced.
12.2(16)BX This command was integrated into Cisco IOS Release 12.2(16)BX.
12.0(26)S This command was integrated into Cisco IOS Release 12.0(26)S.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.