Specifications

mls mpls (guaranteed bandwidth traffic engineering)
MP-143
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mls mpls (guaranteed bandwidth traffic engineering)
To configure the guaranteed bandwidth traffic engineering flow parameters globally, use the mls mpls
command in global configuration mode. To return to the default settings, use the no form of this
command.
mls mpls {g
b-te-burst burst | gb-te-cir-ratio ratio | gb-te-dscp dscp-value [markdown] |
gb-te-enable [global-pool]}
no mls mpls {g
b-te-burst burst | gb-te-cir-ratio ratio | gb-te-dscp dscp-value [markdown] |
gb-te-enable [global-pool]}
Syntax Description
Defaults The default settings are as follows:
• burst is 1000 milliseconds.
• ratio is 1 percent.
• dscp-value is 40.
Command Modes Global configuration
Command History
Usage Guidelines This command is not supported on Cisco 7600 series routers that are configured with a Supervisor
En
gine 2.
Use the mls qo
s map dscp-exp command to reset the Exp value of the Multiprotocol Label Switching
(MPLS) packet when the out-label gets swapped.
gb-te-burst b
urst Specifies the burst duration for the guaranteed bandwidth traffic
engineering flows; valid values are from 100 to 30000 milliseconds.
gb-te-cir-ratio r
atio Specifies the ratio for the committed information rate policing; valid values
are from 1 to 100 percent.
gb-te-dscp dsc
p-value Specifies the differentiated services code point (DSCP) map for the
guaranteed bandwidth traffic engineering flows; valid values are from 0 to
63.
markdown (Optional) Marks down or drops the nonconforming flows.
gb-te-enable Enables the guaranteed bandwidth traffic engineering flow policing.
global-pool (Optional) Specifies using resources allocated from the global pool to the
police traffic engineering flows.
Release Modification
12.2(18)SXE This command was introduced on the Supervisor Engine 720.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.