Specifications

mpls atm multi-vc
MP-151
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls atm multi-vc
Note Effective with Cisco IOS Release 12.4(20)T, the mpls atm multi-vc command is not available in
Cisco IOS software.
To configure a router subinterface to create one or more label virtual circuits (VCs) over which packets
o
f different classes are sent, use the mpls atm multi-vc command in ATM subinterface submode. To
remove the label virtual circuits, use the no form of this command.
mpls atm multi-vc
no mpl
s atm multi-vc
Syntax Description This command has no arguments or keywords.
Command Modes ATM subinterface submode (config-subif)
Command History
Usage Guidelines This command is valid only on ATM MPLS subinterfaces.
Examples The following example shows how to configure interface ATM2/0/0.1 on the networking device for
MP
LS quality of service (QoS) multi-VC mode:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface ATM2/0/0.1 mpls
Router(config-subif)# mpls atm multi-vc
Router(config-subif)# exit
Router(config)# exit
Related Commands
Release Modification
12.0(5)T This command was introduced.
12.0(10)ST This command was modified to reflect Multiprotocol Label Switching
(M
PLS) Internet Engineering Task Force (IETF) syntax and terminology.
12.2(2)T This command was integrated into Cisco IOS Release 12.2(2)T.
12.4(20)T This command was removed.
Command Description
mpls cos-map Creates a class map that specifies how classes map to label virtual circuits
w
hen they are combined with a prefix map.
mpls prefix-map Configures a networking device to use a specified QoS map when a label
d
estination prefix matches the specified access list.