Specifications

mpls ip default-route
MP-172
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls ip default-route
To enable the distribution of labels associated with the IP default route, use the mpls ip default-route
command in global configuration mode.
mpls ip default-route
Syntax Description This command has no arguments or keywords.
Defaults No distribution of labels for the IP default route.
Command Modes Global configuration
Command History
Usage Guidelines Dynamic label switching (that is, distribution of labels based on routing protocols) must be enabled
be
fore you can use the mpls ip default-route command.
Examples The following example shows how to enable the distribution of labels associated with the IP default
ro
ute:
Router# configure terminal
Router(config)# mpls ip
Router(config)# mpls ip default-route
Related Commands
Release Modification
11.1CT This command was introduced.
12.1(3)T This command was modified to reflect new Multiprotocol Label Switching
(
MPLS) Internet Engineering Task Force (IETF) terminology.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
Command Description
mpls ip (global
conf
iguration)
Enables MPLS forwarding of IPv4 packets along normally routed paths for
the platform.
mpls ip (interface
conf
iguration)
Enables MPLS forwarding of IPv4 packets along normally routed paths for
a particular interface.