Specifications

mpls l2transport route
MP-180
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls l2transport route
To enable routing of Any Transport over MPLS (AToM) packets over a specified virtual circuit (VC),
use the mpls l2transport route command in the appropriate command mode. To delete the VC, use the
no form of this command on both provider edge (PE) routers.
mpls l2transport route des
tination vc-id
no m
pls l2transport route destination vc-id
Syntax Description
Defaults Routing of MPLS packets over a specified VC is disabled.
Command Modes Depending on the AToM transport type you are configuring, you use the mpls l2
transport route
command in one of the following command modes:
Command History
destination Specifies the Label Distribution Protocol (LDP) IP address of the remote PE router.
vc-id Assigns a VC number to the virtual circuit between two PE routers.
Transport Type Command Mode
ATM AAL5 and cell
rel
ay
ATM VC configuration mode
Ethernet VLAN Subinterface or interface configuration mode
Frame Relay Connect submode
HDLC and PPP Interface configuration mode
Release Modification
12.1(8a)E This command was introduced.
12.0(21)ST This command was integrated into Cisco IOS Release 12.0(21)ST.
12.0(23)S This command was integrated into Cisco IOS Release 12.0(23)S.
12.2(14)S This command was integrated into Cisco IOS Release 12.2(14)S.
12.2(15)T This command was integrated into Cisco IOS Release 12.2(15)T.
12.2(14)SX This command was introduced on the Supervisor Engine 720.
12.2(17d)SXB Support for this command on the Supervisor Engine 2 was extended to
Ci
sco IOS Release 12.2(17d)SXB.
12.2(27)SBC This command was integrated into Cisco IOS Release 12.2(27)SBC.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.