Specifications

mpls ldp igp autoconfig
MP-228
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls ldp igp autoconfig
To enable Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP) autoconfiguration
on an interface that belongs to an Open Shortest Path First (OSPF) area, use the mpls ldp igp autoconfig
command in interface configuration mode. To disable MPLS LDP autoconfiguration, use the no form of
the command.
mpls ldp igp autoconfig
no mpls ldp igp autoconfig
Syntax Description This command has no arguments or keywords.
Command Default This command works with the mpls ldp
autoconfig command, which enables LDP on all interfaces that
belong to an OSPF area. So, by default, all interfaces are enabled for LDP.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines This command works with the mpls ldp
autoconfig command, which enables LDP on all interfaces that
belong to an OSPF area. To disable LDP on selected interfaces, use the no mpls ldp igp autoconfig
command.
Examples The following example shows how to disable LDP on interface POS1/0:
Router(config)# interface pos1/0
Router(config-if)# no mpls ldp igp autoconfig
Related Commands
Release Modification
12.0(30)S This command was introduced.
12.3(14)T This command was integrated into Cisco IOS Release 12.3(14)T.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.0(32)SY This command was integrated into Cisco IOS Release 12.0(32)SY.
12.2(33)SRB This command was integrated into Cisco IOS Release 12.2(33)SRB.
12.2(33)SCA This command was integrated into Cisco IOS Release 12.2(33)SCA.
Command Description
mpls ldp autoconfig Globally enables LDP on all interfaces that belon
g to an OSPF area.
show mpls interfaces Displays information about interfaces configured for LDP.
show mpls ldp discovery Displays the status of the LDP discovery process.