Specifications

mpls load-balance per-label
MP-271
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls load-balance per-label
To enable the load balancing for the tag-to-tag traffic, use the mpls load-balance per-label command
in global configuration mode. To return to the default settings, use the no form of this command.
mpls load-balance per-label
no mpls load-balance per-label
Syntax Description This command has no arguments or keywords.
Defaults Disabled
Command Modes Global configuration
Command History
Usage Guidelines When you enable load balancing for the tag-to-tag traffic, the traffic is balanced based on the incoming
la
bel (per prefix) among Multiprotocol Label Switching (MPLS) interfaces. Each MPLS interface
supports an equal number of incoming labels.
You can use the sho
w mpls ttfib command to display the incoming label (indicated by an asterisk) that
is included in the load balancer.
Examples This example shows how to enable the load balancing for the tag-to-tag traffic:
Router(config)# mpls load-balance per-label
Router(config)#
This example shows how to disable the load balancing for the tag-to-tag traffic:
Router(config)# no mpls load-balance per-label
Router(config)#
Related Commands
Release Modification
12.2(17b)SXA Support for this command was introduced on the Supervisor Engine 720.
12.2(17d)SXB Support for this command on the Supervisor Engine 2 was extended to
Re
lease 12.2(17d)SXB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
Command Description
show mpls ttfib Displays information about the MPLS TTFIB table.