Specifications

mpls netflow egress
MP-276
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls netflow egress
To enable Multiprotocol Label Switching (MPLS) egress NetFlow accounting on an interface, use the
mpls netflow egress command in interface configuration mode. To disable MPLS egress NetFlow
accounting, use the no form of this command.
mpls netflow egress
no mpls netflow egress
Syntax Description This command has no arguments or keywords.
Command Default This command is disabled.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines Use this command to configure the provider edge (PE) to customer edge (CE) interface of a PE router.
Examples The following example shows how to enable MPLS egress NetFlow accounting on the egress PE
in
terface that connects to the CE interface at the destination Virtual Private Network (VPN) site:
Router(config-if)# mpls netflow egress
Related Commands
Release Modification
12.0(10)ST This command was introduced.
12.1(5)T This command was integrated into Cisco IOS Release 12.1(5)T.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
12.2(33)SCA This command was integrated into Cisco IOS Release 12.2(33)SCA.
Command Description
debug mpls netflow Enables debugging of MPLS egress NetFlow accounting.
show mpls
f
orwarding-table
Displays a message that the quick flag is set for all prefixes learned from
the MPLS egress NetFlow accounting enabled interface.
show mpls interfaces Displays the value of the output_feature_state.