Specifications

mpls traffic-eng area
MP-289
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng area
To configure a router running Open Shortest Path First (OSPF) Multiprotocol Label Switching (MPLS)
so that it floods traffic engineering for the indicated OSPF area, use the mpls traffic-eng area command
in router configuration mode. To disable flooding of traffic engineering for the indicated OSPF area, use
the no form of this command.
mpls traffic-eng area nu
mber
no mpls traffic-eng area nu
mber
Syntax Description
Defaults Flooding is disabled.
Command Modes Router configuration
Command History
Usage Guidelines This command is in the routing protocol configuratio
n tree and is supported for both OSPF and IS-IS.
The command affects the operation of MPLS traffic engineering only if MPLS traffic engineering is
enabled for that routing protocol instance. Currently, only a single level can be enabled for traffic
engineering.
Examples The following example shows how to configure a router running OSPF MPLS to flood traffic
en
gineering for OSPF 0:
Router(config-router)# mpls traffic-eng area 0
number The OSPF area on which MPLS traffic engineering is enabled.
Release Modification
12.0(5)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.