Specifications

mpls traffic-eng atm cos global-pool
MP-291
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng atm cos global-pool
Note Effective with Cisco IOS Release 12.4(20)T, the mpls traffic-eng atm cos global-pool command is not
available in Cisco IOS software.
To specify the class of service for all global pools in traffic engineering tunnels traversing XTagATM
in
terfaces on an ATM-label switch router (LSR), use the mpls traffic-eng atm cos global-pool
command in global configuration mode.
mpls traffic-eng a
tm cos global-pool [available | standard | premium | control]
Syntax Description
Defaults The default class is the lowest, a
vailable.
Command Modes Global configuration (config)
Command History
Usage Guidelines Because this command works at the global rather than at the interface level, it sets the same class of
se
rvice for global pool traffic engineering (TE) tunnel traffic on all XTagATM interfaces of the device.
Examples The following example shows how to specify the second-lowest possible priority class of service for the
gl
obal pool traffic:
Router(config)# mpls traffic-eng atm cos global-pool standard
Related Commands
available | st
andard | premium | control (Optional) Four classes of service, ordered from lowest
priority (available) to highest priority (control). The
default is available.
Release Modification
12.2(8)T This command was introduced.
12.4(20)T This command was removed.
Command Description
mpls traffic-eng atm cos sub-pool Specifies class of service for subpool traffic traversing
Xt
agATM interfaces.