Specifications

mpls traffic-eng atm cos sub-pool
MP-292
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng atm cos sub-pool
Note Effective with Cisco IOS Release 12.4(20)T, the mpls traffic-eng atm cos sub-pool command is not
available in Cisco IOS software.
To specify the class of service for all subpools in traffic engineering tunnels traversing XTagATM
in
terfaces on an ATM-label switch router (LSR), use the mpls traffic-eng atm cos sub-pool command
in global configuration mode.
mpls traffic-eng atm cos sub-pool [a
vailable | standard | premium | control]
Syntax Description
Defaults The default class is the highest, co
ntrol.
Command Modes Global configuration (config)
Command History
Usage Guidelines Because this command works at the global rather than at the interface level, it sets the same class of
ser
vice for subpool traffic engineering (TE) tunnel traffic on all XTagATM interfaces of the device.
Examples The following example shows how to specify the second-highest possible priority class of service for the
subp
ool traffic:
Router(config)# mpls traffic-eng atm cos sub-pool premium
Related Commands
available | standard | premium | control Four classes of service, ordered from lowest priority
(a
vailable) to highest priority (control). The default is
control.
Release Modification
12.2(8)T This command was introduced.
12.4(20)T This command was removed.
Command Description
mpls traffic-eng atm cos global-pool Specifies class of service for global-pool traffic traversing
XT
agATM interfaces.