Specifications

mpls traffic-eng auto-tunnel primary config
MP-307
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng auto-tunnel primary config
To enable IP processing without an explicit address, use the mpls traffic-eng auto-tunnel primary
config command in global configuration mode. To disable this capability, use the no form of this
command.
mpls traffic-eng auto-tunnel primary config unnumber
ed interface
no mpls traffic-eng auto-tunnel primary config unnumber
ed interface
Syntax Description
Command Default Loopback0
Command Modes Global configuration
Command History
Examples The following example enables IP processing on an Ethernet interface:
Router# mpls traffic-eng auto-tunnel primary config unnumbered ethernet1/0
Related Commands
unnumbered in
terface Interface on which IP processing will be enabled without an
explicit address.
Release Modification
12.0(27)S This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.4(20)T This command was integrated into Cisco IOS Release 12.4(20)T.
Command Description
mpls traffic-eng auto-tunnel primary config mpls ip Enables LDP on primary autotunnels.
mpls traffic-eng auto-tunnel primary onehop Automatically creates primary tunnels to all
ne
xt-hops.
mpls traffic-eng auto-tunnel primary timers Configures how many seconds after a failure
pri
mary autotunnels are removed.
mpls traffic-eng auto-tunnel primary tunnel-num Configures the range of tunnel interface
num
bers for primary autotunnels.
show ip rsvp fast-reroute Displays information about fast reroutable
pri
mary tunnels and their corresponding
backup tunnels that provide protection.