Specifications

mpls traffic-eng auto-tunnel primary onehop
MP-309
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng auto-tunnel primary onehop
To automatically create primary tunnels to all next hops, use the mpls traffic-eng auto-tunnel primary
onehop command in global configuration mode. To disable the automatic creation of primary tunnels to
all next hops, use the no form of this command.
mpls traffic-eng auto-tunnel primary onehop
no mpls traffic-eng auto-tunnel primary onehop
Syntax Description This command has no arguments or keywords.
Command Default The dynamically created one-hop tunnels use Loopback0.
Command Modes Global configuration
Command History
Examples The following example automatically creates primary tunnels to all next hops:
Router# mpls traffic-eng auto-tunnel primary onehop
Related Commands
Release Modification
12.0(27)S This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.4(20)T This command was integrated into Cisco IOS Release 12.4(20)T.
Command Description
mpls traffic-eng auto-tunnel primary config Enables IP processing without an explicit
a
ddress.
mpls traffic-eng auto-tunnel primary onehop Enables LDP on primary autotunnels.
mpls traffic-eng auto-tunnel primary timers Configures how many seconds after a failure
pri
mary autotunnels are removed.
mpls traffic-eng auto-tunnel primary tunnel-num Configures the range of tunnel interface
num
bers for primary autotunnels.
show ip rsvp fast-reroute Displays information about fast reroutable
pri
mary tunnels and their corresponding
backup tunnels that provide protection.