Specifications

mpls traffic-eng auto-tunnel primary timers
MP-310
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng auto-tunnel primary timers
To configure how many seconds after a failure primary autotunnels are removed, use the mpls
traffic-eng auto-tunnel primary timers command in global configuration mode. To disable this
configuration, use the no form of this command.
mpls traffic-eng auto-tunnel primary timers re
moval rerouted sec
no mpls traffic-eng auto-tunnel primary timers r
emoval rerouted sec
Syntax Description
Command Default None
Command Modes Global configuration
Command History
Examples The following example shows that primary autotunnels are removed 100 seconds after a failure:
Router# mpls traffic-eng auto-tunnel primary timers removal rerouted 100
Related Commands
removal rerouted se
c Number of seconds after a failure that primary autotunnels are removed.
Valid values are 30 to 604,800. Default: 0.
Release Modification
12.0(27)S This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.4(20)T This command was integrated into Cisco IOS Release 12.4(20)T.
Command Description
mpls traffic-eng auto-tunnel primary config Enables IP processing without an explicit
a
ddress.
mpls traffic-eng auto-tunnel primary tunnel-num Enables LDP on primary autotunnels.
mpls traffic-eng auto-tunnel primary onehop Automatically creates primary tunnels to all
ne
xt hops.
mpls traffic-eng auto-tunnel primary tunnel-num Configures the range of tunnel interface
num
bers for primary autotunnels.
show ip rsvp fast-reroute Displays information about fast reroutable
pri
mary tunnels and their corresponding
backup tunnels that provide protection.