Specifications

mpls traffic-eng flooding thresholds
MP-320
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng flooding thresholds
To set a reserved bandwidth thresholds for a link, use the mpls traffic-eng flooding thresholds
command in interface configuration mode. To return to the default settings, use the no form of this
command.
mpls traffic-eng flooding thresholds {do
wn | up} percent [percent ...]
no mpls traffic-eng flooding thresholds {down | up}
Syntax Description
Command Default None
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines When a threshold is crossed, Multiprotocol Label Switching (MPLS) traffic engineering link
ma
nagement advertises updated link information. If no thresholds are crossed, changes can be flooded
periodically unless periodic flooding is disabled.
Examples The following example shows how to set the reserved bandwidth of the link for decreased (down) and
fo
r increased (up) thresholds:
Router(config-if)# mpls traffic-eng flooding thresholds down 100 75 25
Router(config-if)# mpls traffic-eng flooding thresholds up 25 50
100
down Sets the thresholds for decreased reserved bandwidth.
up Sets the thresholds for increased reserved bandwidth.
percent [pe
rcent] Bandwidth threshold level. For the down keyword, valid values are from 0
through 99. For the up keyword, valid values are from 1 through 100.
Release Modification
12.0(5)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
12.2(33)SCA This command was integrated into Cisco IOS Release 12.2(33)SCA.