Specifications

mpls traffic-eng link timers bandwidth-hold
MP-323
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng link timers bandwidth-hold
To set the length of time that bandwidth is held for a Resource Reservation Protocol (RSVP) PATH (Set
Up) message while waiting for the corresponding RSVP RESV message to come back, use the mpls
traffic-eng link timers bandwidth-hold command in global configuration mode.
mpls traffic-eng link timers bandwidth-hold hol
d-time
Syntax Description
Defaults 15 seconds
Command Modes Global configuration
Command History
Examples The following example sets the length of time that bandwidth is held to 10 seconds.
Router(config)# mpls traffic-eng link-management timers bandwidth-hold 10
Related Commands
hold-time Sets the length of time that bandwidth can be held. The range is from 1 to
300
seconds.
Release Modification
12.0(5)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
Command Description
show mpls traffic-eng link-management
ba
ndwidth-allocation
Displays current local link information.