Specifications

mpls traffic-eng link-management timers bandwidth-hold
MP-325
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng link-management timers bandwidth-hold
To set the length of time that bandwidth is held for an RSVP path (setup) message while you wait for the
corresponding RSVP Resv message to come back, use the mpls traffic-eng link-management timers
bandwidth-hold command in global configuration mode. To disable this function, use the no form of
this command.
mpls traffic-eng link-management timers bandwidth-hold hol
d-time
no mpls traffic-eng link-management timers bandwidth-hold
Syntax Description
Defaults 15 seconds
Command Modes Global configuration
Command History
Examples In the following example, bandwidth is set to be held for 10 seconds:
Router(config)# mpls traffic-eng link-management timers bandwidth-hold 10
Related Commands
hold-time Length of time that bandwidth can be held. Valid values are
fro
m 1 to 300 seconds.
Release Modification
12.0(5)S This command was introduced.
12.1(3)T This command was integrated into Cisco IOS Release 12.1(3)T.
12.0(10)ST This command was integrated into Cisco IOS Release 12.0(10)ST.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
Command Description
show mpls traffic-eng link-management
ba
ndwidth-allocation
Displays current local link information.