Specifications

mpls traffic-eng link-management timers periodic-flooding
MP-326
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng link-management timers periodic-flooding
To set the length of the interval for periodic flooding, use the mpls traffic-eng link-management timers
periodic-flooding command in global configuration mode. To disable the specified interval length for
periodic flooding, use the no form of this command.
mpls traffic-eng link-management timers periodic-flooding in
terval
no mpls traffic-eng link-management timers periodic-flooding
Syntax Description
Defaults 180 seconds (3 minutes)
Command Modes Global configuration
Command History
Usage Guidelines Use this command to advertise link state information changes that do not trigger immediate action. For
e
xample, a change to the amount of allocated bandwidth that does not cross a threshold.
Examples The following example shows how to set the interval length for periodic flooding to 120 seconds:
Router(config)# mpls traffic-eng link-management timers periodic-flooding 120
Related Commands
interval Length of the interval (in seconds) for periodic flooding. Valid values are
f
rom 0 to 3600. A value of 0 turns off periodic flooding. If you set this value
from 1 to 29, it is treated as 30.
Release Modification
12.0(5)S This command was introduced.
12.1(3)T This command was integrated into Cisco IOS Release 12.1(3)T.
12.0(10)ST This command was integrated into Cisco IOS Release 12.0(10)ST.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
Command Description
mpls traffic-eng flooding thresholds Sets a link’s reserved bandwidth thresholds.