Specifications

mpls traffic-eng tunnels (global configuration)
MP-355
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
mpls traffic-eng tunnels (global configuration)
To enable Multiprotocol Label Switching (MPLS) traffic engineering tunnel signaling on a device, use
the mpls traffic-eng tunnels command in global configuration mode. To disable MPLS traffic
engineering tunnel signaling, use the no form of this command.
mpls traffic-eng tunnels
no mpls traffic-eng tunnels
Syntax Description This command has no arguments or keywords.
Defaults The command is disabled.
Command Modes Global configuration
Command History
Usage Guidelines This command enables MPLS traffic engineering on a device. For you to use the feature, MPLS traffic
en
gineering must also be enabled on the desired interfaces.
Examples The following example shows how to turn on MPLS traffic engineering tunnel signaling:
Router(config)# mpls traffic-eng tunnels
Related Commands
Release Modification
12.0(5)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
Command Description
mpls traffic-eng tunnels (interface
conf
iguration)
Enables MPLS traffic engineering tunnel
signaling on an interface.