Specifications

show acircuit checkpoint
MP-424
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show acircuit checkpoint
To display checkpointing information for each attachment circuit (AC), use the show acircuit
checkpoint command in privileged EXEC mode.
show acircuit checkpoint
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is used for interface-based attachment circuits. For Frame Relay and ATM circuits, use
th
e following commands to show redundancy information:
• debug atm ha-error
• debug atm ha-events
• debug atm ha-state
• debug atm l2transport
• debug frame-relay redundancy
Examples The following sho
w acircuit checkpoint command displays information about the ACs that have been
check-pointed. The output varies, depending on whether the command output is for the active or standby
Route Processor (RP).
On the active RP, the command displays the following output:
Router# show acircuit checkpoint
AC HA Checkpoint info:
Last Bulk Sync: 1 ACs
AC IW XC Id VCId Switch Segment St Chkpt
---- ---- ---- --- ---- -------- -------- -- -----
HDLC LIKE ATOM 3 100 1000 1000
0 N
VLAN LIKE ATOM 2 1002 2001 2001 3 Y
Release Modification
12.2(25)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.