Specifications

show atm vc
MP-430
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
Leaf Atm Nsap address: 47.0091810000000002BA08E101.444444444444.02
Leaf Atm Nsap address: 47.0091810000000002BA08E101.333333333333.02
Leaf Atm Nsap address: 47.0091810000000002BA08E101.222222222222.02
The following is sample output from the show atm vc command where no VCD is specified and private
VCs are present:
Router# show atm vc
AAL / Peak Avg. Burst
Interface VCD VPI VCI Type Encapsulation Kbps Kbps Cells Status
ATM1/0 1 0 40 PVC AAL5-SNAP 0 0 0 ACTIVE
ATM1/0 2 0 41 PVC AAL5-SNAP 0 0 0 ACTIVE
ATM1/0 3 0 42 PVC AAL5-SNAP 0 0 0 ACTIVE
ATM1/0 4 0 43 PVC AAL5-SNAP 0 0 0 ACTIVE
ATM1/0 5 0 44 PVC AAL5-SNAP 0 0 0 ACTIVE
ATM1/0 15 1 32 PVC AAL5-XTAGATM 0 0 0 ACTIVE
ATM1/0 17 1 34 TVC AAL5-XTAGATM 0 0 0 ACTIVE
ATM1/0 26 1 43 TVC AAL5-XTAGATM 0 0 0 ACTIVE
ATM1/0 28 1 45 TVC AAL5-XTAGATM 0 0 0 ACTIVE
ATM1/0 29 1 46 TVC AAL5-XTAGATM 0 0 0 ACTIVE
ATM1/0 33 1 50 TVC AAL5-XTAGATM 0 0 0 ACTIVE
When you specify a VCD value and the VCD corresponds to that of a private VC on a control interface,
the display output appears as follows:
Router# show atm vc 15
ATM1/0 33 1 50 TVC AAL5-XTAGATM 0 0 0 ACTIVE
ATM1/0: VCD: 15, VPI: 1, VCI: 32, etype:0x8, AAL5 - XTAGATM, Flags: 0xD38
PeakRate: 0, Average Rate: 0, Burst Cells: 0, VCmode: 0x0
XTagATM1, VCD: 1, VPI: 0, VCI: 32
OAM DISABLED, InARP DISABLED
InPkts: 38811, OutPkts: 38813, InBytes: 2911240, OutBytes: 2968834
InPRoc: 0, OutPRoc: 0, Broadcasts: 0
InFast: 0, OutFast: 0, InAS: 0, OutAS: 0
OAM F5 cells sent: 0, OAM cells received: 0
Status: ACTIVE
Table 14 describes the fields shown in the displays.
Ta b l e 14 show atm vc Field Descriptions
Field Description
Interface Interface slot and port.
VCD/Name Virtual circuit descriptor (virtual circuit number). The connection name is
di
splayed if the virtual circuit (VC) was configured using the pvc command and
the name was specified.
VPI Virtual path identifier.
VCI Virtual channel identifier.