Specifications

show controllers vsi control-interface
MP-436
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show controllers vsi control-interface
Note Effective with Cisco IOS Release 12.4(20)T, the show controller vsi control-interface command is not
available in Cisco IOS software.
To display information about an ATM interface configured with the tag
-control-protocol vsi command
to control an external switch (or if an interface is not specified, to display information about all Virtual
Switch Interface [VSI] control interfaces), use the show controllers vsi control-interface command in
user EXEC or privileged EXEC mode.
show controllers vsi control-interface [in
terface]
Syntax Description
Command Modes User EXEC (>)
Privileged EXEC (#)
Command History
Examples The following is sample output from the sho
w controllers vsi control-interface command:
Router# show controllers vsi control-interface
Interface: ATM2/0 Connections: 14
The display shows the number of cross-connects currently on the switch that were established by the
MPLS LSC through the VSI over the control interface.
Table 17
describes the significant fields shown in the display.
Related Commands
interface (Optional) Specifies the interface number.
Release Modification
12.0(5)T This command was introduced.
12.4(20)T Thsi command was removed.
Ta b l e 16 show controllers vsi control-interface Field Descriptions
Field Description
Interface The (Cisco IOS) interface name.
Connections The number of cross connections currently on the switch.
Command Description
tag-control-protocol vsi Configures the use of VSI on a control port.